Wrist joints help?

[trekking95]

Well as we all know The Avengers figures have no wrist joints. There are a few other joints they don't have but I think the wrist is the most important since you can get better poses with them holding their weapons.

So is there a way to make wrist joints? Like somehow cut off the hands and stick them back on with a peg?
A way to fix broken wrist joints on figures that have them could likely be used here.

Thanks!!

[trekking95]

Seriously, someone must know something about this! This is a custom figure site after all!!!

And yes, I looked in the tutorials area. All the joint stuff I could find was for the 6 in. figures. The joints on 3.75 in. figures are too small for those ways of doing it.

[cosmicfantasycustoms]

revoltech joints could help. check out countpichula's thread in the custom workstation to see them in action. if you are talking about 3.75 inch figs, you might have to go and buy a revoltech figure, which are not cheap. but you can get a set of the joints off of ebay. hope this helps.

[trekking95]

revoltech joints could help. check out countpichula's thread in the custom workstation to see them in action. if you are talking about 3.75 inch figs, you might have to go and buy a revoltech figure, which are not cheap. but you can get a set of the joints off of ebay. hope this helps.

Are the joints small enough for the 3.75 in. figures? The ones I saw on eBay look like they have a large ball joint in the center.

[cosmicfantasycustoms]

you may need to pick up a revoltech fig for some of the joints for those figs. the ones in the pack are for larger figs and might not look proper on that size of figure.

[kadenscott]

revoltech joints could help. check out countpichula's thread in the custom workstation to see them in action. if you are talking about 3.75 inch figs, you might have to go and buy a revoltech figure, which are not cheap. but you can get a set of the joints off of ebay. hope this helps.

Thanks for the help.