Need help.

[John11756]

so i am working on a deadpool custom and I accidently tore more than the peg off one of the ball shoulder jointes on the ML Bullseye body, would anyone happen to have one i could buy or something? i dont have much for trade but ill try to post what i have. i also need the Katannas from the hand ninja or the ronin set, they also came with the two pack Deadpool.

[Green Skin]

Post a picture of it if you can. I might have the part you need, but I'm not sure.

[John11756]

Here is the part.

[John11756]

[EDarthT]

Can't really see anything wrong with that but just in case here's a couple of links to some paint rub tutorials I did, you might find something useful in there

http://www.figurerealm.com/viewcustomtutorial.php?id=69

http://www.figurerealm.com/viewcustomtutorial.php?id=70

If you've stretched the peg that fits into the arm then you're gonna have to switch the whole peg out with a screw, just find one the right size, cut off the stretched peg, leaving enough to insert the screw and drill a small hole in the remaining part of the peg, small dab of superglue on the end of the screw and screw it into the hole on the piece of peg. It's quite a tricky method to learn but once you've learnt it it's easy as pie so i'd suggest practising first and do a lot of test fitting without the glue.

[John11756]

i tore past the peg that was the part i need not the part i damaged. basically the peg came off with part of the ball joint.

[John11756]

[EDarthT]

Aaahh, now I see, yeah, sorry to say but that looks pretty much done for to me. Maybe someone else has a method of fixing it but I'm out of ideas. So I'll leave you with this bullseye is done on the same body as a fair few other legends so the same joint off any of these would work easily as a replacement. Moonknight, quicksilver, captain marvel and tarantula to name a few so of you're looking for a replacement don't just limit it to bullseye.

[John11756]

thank you.