Red Hood Custom Action Figure

Esbat's Marvel Legends Style Red Hood

Step One: Dismember Mojo Series Longshot, Galactus Series Bullseye, and Decapitate DC Direct Lighting Lad
Step Two: Discard Longshot and Lighting Lad
Step Three: Ignore custom for 3 months
Step Four: Dremel the facial features off of Bullseye head, paint base coat of custom purple mix, and then proceed to paint it red.
Step Five: Drop head repeatedly
Step Six: Dismember McFarlane Onimusha 2 Jubei Yagyu Figure, paint armor coat purple.
Step Seven: Abandon armor coat and Jubei figure
Step Eight: Trade on The Fwoosh for pair of guns and sleeveless jacket-coat
Step Nine: Use Elmer's Ultimate Glue to secure a decapitated screw into neck post of Bullseye body
Step Ten: Dremel a hole in underside of Bullseye head for screw threads to grip
Step Eleven: pretty girl about lack of ball joint head articulation
Step Twelve: Consider custom done
Step Thirteen: Return 3 months later to complete custom
Step Fourteen: Wake up from fever dream, swear loudly upon sight of unfinished figure
Step Fifteen: Paint boots noir black, patch holes in left leg and around base of neck with Creative Paperclay, use black sharpie to paint paperclay black.
Step Sixteen: Paint gloves brown
Step Seventeen: Paint upper body up to shoulder joints white
Step Eighteen: Laugh at Dr Nightmare for suggesting Ball Bearing and Rare Earth Magnet Head fix
Step Nineteen: Remove screw neck post and replace with ball bearing and glue magnet into base of figure's skull
Step Twenty: Ignore Doc's gloating
Step Twenty One: Paint ball bearing black, coat painted sections in matte and gloss clear coats
Step Twenty Two: Place jacket on too early and smudge paint job on upper body and neck
Step Twenty Three: Add pistols, pose, swear at smudge paint discovery
Step Twenty Four: Say F*** It and take photos
Step Twenty Five: Upload only one photo and type out 25 step recipe guide