After finding Xorn and removing his mask, I realized I needed to make a Magneto using that head. Only problem it was too small for the Hasbro body! Fortunatly Moon Knight/Bullseye's body fit the bill. I used Spider Woman's man-hands, Dr Doom's cape, and a ML3 Magneto Helmet to complete the image of more athletic Magneto. The base came from some Dusty Trails figure and I attached painted 'junk' to wire ties so they could be posed around and appeared levitating under him. Some hand-detailing and aibrushing later, Magneto was done and ready to terrorize the world!
Now I gotta go buy a couple Xorns!
You have to judge it Just right for the time to do so but it does let you expand the face diameter slightly
You do have to have some upper body strength and time to spare basically hold this position for 10-20 minutes while the cast sets - its actually tougher than it sounds
But hell of a workout
The other way to do it is use a plasticine mold or Carpenters Putty and pull it open slightly after you make your
initial impression with your subject then fill the mold making absolutely sure you don't smudge or screw up the mold
~_O
Dedi
Paint apps are sublime
Theres been plenty times in the 90s when proportional anatomy was thrown out the window and you had loads of people wondering about with huge over developed bodies and small heads
This custom is more in proportion than those drawings were
Superb work Jin
~_@
Dedi