I had all the other Jason's including the Roy Burns and part 8 Jason which I had to customize, but the only one I did not have was the original part 3 which I missed out on, years went by so I decided to do my own. I took the shirt off the TCM figure, kept the trousers, and painted them a lighter grey. the boots were bulky, so I swapped them for the boots on my Jason goes to hell which suits him better. the rings I had to sand down, I took the hair off and re-sculpted the face using putty. I got the shirt off my part 4 Jason and made a completely new one for that which I'd darkened to make it look more like it did in part 4. Now with the light green shirt, I put on my new figure and padded it out a little on the upper back part to give it that slight hunch-back like in the film. the mask I made out of putty but it seemed a little too big so I swapped it for the mask on the MEZCO 9" exaggerated Jason and put mine on which suited that better too. The mezco mask had a crack at the side of the mask like in the film so I had to fill that in with putty and re-paint the mask and also take the plastic straps off and put leather straps on to fit the head design of my new Jason.
