Red Son Superman Custom Action Figure

You can get it at JoAnn's, dude. It's a small clear bottle with a blue cap. Make sure you store it upright, or it can dry in the tube like glue. If it does, use the sharp end of a safety pin to poke through it from the opening.

Thanks for looking. Cut the cloth to the shape you want. Seal the edges with a fabric sealer-this hardens the edges and helps posing. After the fabric sealer is dry, put the whole cape into a glass of water till it soaks and quickly remove. Place the cape, completely open, onto a hand towel-fold it over the cape and press it down to soak out the water from the cloth. It will be damp. While it's damp, use superglue (I use loc-tite) to attach it to the back near the neck. Try to use tweezers or some other tool-if you touch it with your finger you will glue your finger. Depending on the look, I may fold the outer edges over near the neck line to hold that edge's crease. Because the cape is wet, you won't get the glue turning white as it dries like you will if you just glue it on dry. To add creases/folds to the cape, make the folds and lay the figure down on his back on top of the cape,for a few minutes and then pick him up--the folds will be just enough to stay as the cape air dries. Has worked EVERY single time for me. Hope this helps!