You are a Guest
Sign In?
 
 
LED Light-up Effects
This tutorial teaches you how to add an extra level of creativity and value to your customs by showing you how to add LED light-up effects!
(by Mint Condition Customs)   Update Tutorial

A quick note: This article deals with properly installing an LED circuit in an action figure, and talks about how the electricity in a circuit flows (such as with the positive and negative sides of wires, etc.). It does not teach you how to solder said LED circuit. If you need to learn how to solder, please refer to my other tutorial which talks specifically, and in detail, how to solder. Thank you.

So, installing LED’s. It can really give some extra value to a custom, if you can make a part of the figure light up. For some characters, it’s almost essential. Here, I’ll teach you how to set up a circuit, and how to make it fit inside of an action figure to make it light up. I’ll even teach you how to make a removable battery compartment on the back for easy access to changing out the battery.

What you’ll need for this tutorial: an led, some wire, a switch, a battery, a battery holder, a dremel, supplies to solder, a lo-temp hot glue gun, and some two-part epoxy resin.

Alright, ready to get started? Let’s begin!

And that’s the end of the guide. I hope it helps!


Disclaimer
Make sure you have read the disclaimer before attempting anything mentioned in the tutorial.

No user comments found.

Back to the Custom Tutorial Index

Custom Items for Sale