**Just wanted to repost this, as it's back up on eBay**
Been too long since I submitted my last custom, so here is my latest; Ghost Rider!! I feel there still hasn't been a decent GR figure made in this scale. For some reason, each GR figure out there is basically a skull, with some horrible orange fire stuck on top. I've always felt that a good Ghost Rider skull should look ENGULFED in flames, so I did the following:
Head: Kingdom Come Deadman skull, with sculpted Hot Glue flames
Body: Chest and hips are ML Shield Agent
Arms & Thighs: Spider-Man 2 Doc Ock
Shoulders: ML Longshot
Boots: Face Off Jigsaw
I first cracked the body open, and ground down the shoulder sockets to cut down on paint rub. I then cut the Prototype jacket just at the seam on the chest, and attached it to the torso. I sculpted the 'flap' on the front of the chest, an used the flat ends from some pins for the 'snaps' on the chest and collar.
I used my dremel to cut off the shield agent's neck, and then hollowed out the neck cavity and chest area. I put in a clear drywall screw anchor, and sealed it off with hot glue flames. The anchor acted as a socket for the clear ball joint for the head. I dremeled out a hole in the Deadman skull, and applied it to the figure.
The chains are craft chains from Jo Anne Fabrics, and the hooks are from a Raven Spawn figure. The flaming chain effects are from hot glue, again. All hot glue flames on this figure were painted over with clear Tamiya yellow, orange and red.
All spikes are actually thumbtacks, with the flat bits cut off. Belts are from the gurney of a Spawn: Clown III figure. Everything else painted with Citadel paints, and sealed with Testor's Dullcote.
Enjoy, and let me know what you think!!
|Eliot Franklin||Submission Order||Ultimate Beast|
|Eliot Franklin||Marvel Legends Series||Ultimate Beast|
|Cable||Created by Heroes Assembled Customs||Mr. Freeze|