Jin's LED Light-Up Tutorial!

Posted in Custom Workstation

This guide has been requested quite often and I would of had it done earlier but I was looking for some sort of pre-assembled kit that could be fit into most figure. Well I just couldn't find one so this guide will help you make your own LED setup and install it into most hollow-chest figures. Keep in mind this won't work for all figures and you'll need to modify the steps to fit. But the basic principal is there, build a case, wire the unit, placement of the parts, etc. I recommend you get the Cold Heat soldering tool from Radio Shack to solder with. It's 0 mess, won't burn you, and works so much better than the always-hot tools that stink up the place.

Custom LED Guide

Hope this helps and good luck customizing!