Paint rub problem!

No it isn't it just fits well.

So is the sword pemanently stuck in the hand?

I fixed the problem after all this woreing all I ended up doing was heating up the hand shoving the sowrd in and letting it cool so n that the hand fits around the sowrd perfictly. Sorry if I over reacted I was just worried that all my countless hours put into this figure would be waisted dou to paint rub. Thanks for all the goold advice I'm shure I will be able to use it on another figure.

they sell a brush on matte sealer as well, or there is dullcote!

I just had the thought thet I could reschulpt the thumb so it isn't in the way so the sowrd can slip in and out easaly withought falling out. If this doesn't work I will try the super glue method sugested above.

Try to find brush super glue this way you can spread it where u need it. Super Glue does turn glossy however so you may want to then spray it with a matte finish.

Ok thanks I'll do that I just hope I don't wreck him.

I thought about doing that but I didn't want to wreck the hand.

Practice on a spare hand or one your not bothered about until you feel confident enough to go for it

Is there anything I can use wich will leve the hand its origanall coller and won't make it glossy?

I thought about doing that but I didn't want to wreck the hand.

How about adding articulation to the hand so it can be opened and closed before inserting the sword, there's a tutorial on here somewhere?,

Here it is
http://www.figurerealm.com/customtutori ... view&id=44

try putting a sealer on the hand.