Dcuc height question

im talking about when you take the lower legs off the upper legs to put a new set on I tried heating it up but I couldnt push the peg through.

I don't think there a tutorial for it, but how I do it, is I cut off the old peg, then drill a whole through the new one, and a drill a whole into the hip, then put a tiny screw through both of them to hold it together so that it will never break, then I glue the whole thing, so that the screw never comes out. This also works on shoulder pegs, it's a lot of work but it will never break

could sombody point me in the direction of a tutorial to show you how to put the pegs back into the legs when im switching them out

ill try it again and see.

That's where good old fashioned customizing comes into play It's pretty simple, just but glew and sand, and sometimes sculpt a little to smooth out the transitions (:

I tried the dcsh legs the pieces didn't work the hole for the peg was to big on the dcsh. I've seen people take superboy from the waist down and it works but I can't find him anywhere for less than thirty bucks.

you could give him legs from the old DC Super Heroes Robin but leave the ankles and hips so that you don't loose articulation. I think superboys legs would be to big on a robin.