After watching the Arkarm Origins Trailer, I got inspired to do something. At about 1:43-1:49 an explosion is set off and Batman jumps through a wooden gate. I tried to do this effect as a test for...[See More]

I was messing around with a cap figure. He is from the new series for MU Infinite, but he is a reissue of the same exact figure from MU. The leg is very loose and certain things are lacking, so I...[See More]

A good buck that is solid and well articulated. So why the redo of this figure? That bight red really toyish look with the barely metallic yellow just didn't look right. The cape was to hard and...[See More]

This is my first custom action figure. He is for a diorama most likely. I had a bunch of DCU figures for like 2 years, but never really did any thing with them. The large gaps from the...[See More]

The weight lifting stuff was made a while back for a Rock figure. He was sold out by the time I went to buy him. Mark Henry was another choice, but he has a fist and open hand, which isn't good for...[See More]

Spidey and the Lizard were on discount for 3.99 each, so I bought these two figures with the idea of doing a sewer battle that would be similar to the movie. The scale for the Lizard is way off, but...[See More]

The Havok figure from MU has nice painted detail but is way too thin as a sculpt. Alex is usually similar to Hawkeye in build. The legs are way too thin and it bothered me to the point that I had to...[See More]

Something that I wanted to do with a "Spiderman Fearsome Foes" figure because the articulation wasn't good. During commercials, I decided to make something with rubberbands to resemble Toxin. It...[See More]

This is a dojo that I built a while ago specifically for these type of figures. I forgot the company that makes these street fighter figures. They are not made very well, but its ok since it was a...[See More]

This is the first actual custom that I made with out completely messing up a figure because I was able to use the hands and head extras. "Go Native Blanx" is what I used for such a stange custom....[See More]

This is a part or section of a house that was built to display both a front and back. It is barely 6x12 inches bus has good perspectives for posing. I focused on detail using scrap wood and plaster...[See More]

This is the left over legs from another project that just had to be used in an artist and creative way. I use it as part of the Silver Surfer vs. Namor diorama. Although, Namor has gone toe to toe...[See More]

A 14 by 21 inch ABS plastic sheet was painted with quality enamels to begin the ocean look. The more complex part was to create a wave and foam effect around Namor and the board that is emerging...[See More]