So, I bought this with the intent to repaint it, so this wasn't that much of a trek for me. I really love the sculpt, but some aspects of the articulation could've been better. Really, the hips --...[See More]

Here's the OC I've been working on for a while. I DID NOT sculpt: Gun (aside from the handle) Joints + sockets GI: Joe Straps (ankles and holster connection) Everything else was sculpted using super...[See More]

Really did a lot of work to this guy. I removed the shoulderpads completely, and attached them through some of the stretchy GI-Joe strap fabric, so they could move as they would in the CGI cutscenes....[See More]

Using the HG G-EXES as a base, I swapped out several parts from several different kits to make this. Many things come from items I can't recall, but the primary change (head) comes from the...[See More]

Took the original McFarlane Anniversary 'Chief and swapped out the shoulders (raising them, slightly bending the biceps forward), removed the visor, sanded it down, and did some paint washes....[See More]

A simply paintjob for Donatello. Not the best, but it suits my needs....[See More]

A simple deku-baba sculpt to act as an accessory to Young Link....[See More]

A complete revision of my original Young Link figure. The intent was to make it look more like link, and completely change the articulation/overall "rough" appearance. EDIT: the "accessories" photo...[See More]

Using the red Hazop figure from mcfarlane, I editted the ball joint on an old Halo 3 Spartan mark V's neck to work properly with the reach figures, and simply stuck on the mjolnir armour pads....[See More]

I was relatively satisfied with my Halo: Reach ODST, until I actually looked at a direct screenshot of one of the ODSTs ingame. I decided that I might as will try to make it look like it should, and...[See More]

Using an ARF trooper for the base, I swapped out his arms/lower legs, and cut a hood to bits to create the scarf/camo hood. Afterward, I went over with a grey, then olive streaks, and light grey...[See More]

Using the ARF Trooper figure as a base, I compiled the upper neck-brace from a red Clone Commander figure, cutting off the left shoulder pad, and replacing it with the pad used on one of the original...[See More]

This was made using Super Sculpey, Hobby Base joints, and a kitbashed skirt piece from a Play Arts figure. The figure is around 4 inches tall, is fully poseable, and contains the following...[See More]