A lot of going back and forth with this one, between cutting up pieces I needed, sizing them up, repeat if necessary. The 3 wings were wings from an X-wing, with the top wing being shortened. With the top wing, because the bottom of the wing is now visible, there is a square design that was noticeable. I cut up a small piece of stryene sheet, filed it down and covered it so its not too noticeable (last picture). The engines are X-wing laser cannons, cut up and turned around. The engines had a slot for where the laser cannons were, I had to cut a notch so the engines could fit on the wings. The very back of the engines were ends of an X-wing engine (dark gray area). The astromech socket was covered up with a small piece of cardboard, then tamiya putty. Afterwards I cut a very small piece of a wing, filed it down and covered the socket entirely. The tip of the T-wing was cut off at an angle, covered with tamiya putty and laser cannons applied (tips from X-wing laser cannons). The front landing gear is still intact.