I always didn't care for the way mattel designed the JLU Superman figure. The hunched over look & his legs were just way too short & stumpy IMO & just looked silly. He's the man of steel, should stand taller then most characters. So I decided to fix that. I made one for myself with a similar technique but I designed him in the STAS look. Someone wanted me to make one on consignment but they wanted it to still have the Justice League head. After experimenting on a couple of these for myself. I think I developed the easiest technique to make this figure. So that's the route I took on this one. All I did was cut a JLU Superman in half & cut a mattel TNBA Batman in half so I could use the bottom half from him. Sculpted new underwear & boot lines. Then just repainted the entire figure. Not really all that tough to do, but a definite improvement.